Loading ...
Loading ...
Loading ...
nil ii,, ,, inl ,,,11,1uu n
SERVUCE AND ADJUSTMENTS
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig° 33)
• Block up axle securely
• Remove axle cover, retaining ring and washersto allow
wheel removal
• Repair tire and reassemble.
° Replace washers and snap retaining ring securely in
axle groove.
• Replace axle cover.,
WASHERS
RETAINING
RING _
AXLE \
COVER \
FIG. 33 i "
REAR WHEEL -
• Block rear axle securely_
• Remove five (5) hub bolts to allow wheel removal.
• Repair tire and reassemble. Replace and tighten hub
bolts securely.
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 34)
CAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection
when around batteries.
tf your battery istoo weak to start the engine, itshould be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR 1SEQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES
TO ATTACH .JUMPER CABLES -
• . G6nnect ea:cli'end oi the REI3 cable,to the P.OSITIV_
T1VE (-) tertfl_i_alof fu]lycharge_l battery., ' " '"
. Connect the other end of the BLACK cable to a panet
bolt on the left side of the tractor, away from fuel tank
and battery,
TO REMOVE CABLES, REVERSE ORDER -
° BLACK cabte first from chassis and fuNy charged
battery,
° RED cable last from both batteries,
23
O
LH.
PANEL
BOLT
]
FIG_ 34
, i
TO REPLACE HEADLIGHT BULB
- Raise hood°
- Pull bulb holder out of the hole in the backside of the
gd]L
° Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
. Close hood
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting
° Check wiring, See electrical wiring diagram in Repair
Parts section of this manual°
TO REPLACE FUSE
Replace with 30 amp automotive4ype phJg-in fuse The
fuse holder is located behind the dash.
Loading ...
Loading ...
Loading ...