Loading ...
Loading ...
Loading ...
SERVRCE AND ADJUSTMENTS
ii ,u,i H, UHH,,,,,,,,, In, I ,U n UU, n,q 'U ' .....................................
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
o Depress clutch/brake pedal fully and set parking brake.
• Place gearshift lever in neutral (N) position.
° Place attachment clutch in "DISENGAGED" position.
• Turn ignition key "OFF" and remove key.
o Make sure the blades and all moving parts have completely stopped.
- Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
i1, m,,, n UI,,,,,,,, In,HI q,,, nm U,U,H,U,, II,lr
TRACTOR TO LEVEL MOWER HOUSING
TO REMOVE MOWER (See Fig. 22)
• Place attachment ctutch in "DISENGAGED" position
° Turn height adjustment knob to lowest setting.
• Lower mower to its lowest position
• Remove retainer spring holding anti-swaybar to chas-
sis bracket and d sengage ant -swaybar from bracket
:• Remove retainer springs from suspension arms at
•deckhand d sengage arm€ _'roh_deqk.
° Raise att'abhmeot lift to'i_shighest p,ositiOr_ " ',
- Remove two retainer springs from e&ch front link and
remove links.
• Slide mower forward and remove belt from electric
clutch pulley
• Slide mower out from under right side of tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK _STO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
ADJUSTMENT
SUSPENSION NUTS LIFT
ARMS LINKS
FRONT
SUSPENSION
BRACKET
BRACKET
Adjust the mower while tractor is parked on level ground or
driveway Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3 of this manual),
Iftires are over or underinfiated, you wii! not property adjust
your mower_,
SIDE-TO-SIDE ADJUSTMENT (See Fig& 22 and 23)
Raise mower to its highest position.
• Measure height from bottom of deck curl to ground
levei at front corners i)f mo_ver.'. Distance "A" on both
- sides ()[ _ower shbuld be the sameo: i. -
_' tf adjustment is ne_essary,make adjustnqent on one
side of mower dnly.
• To raise one side of mower, tighten lift link adjustment
nut on that side.
° To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 3(16".
Recheck measurements after adjusting.
FIG. 23
CHASSIS
RETAINER
SPRING
/
ANTI-SWAY RETAINER
BAR SPRINGS
FIG_ 22
19
\
BRACKET
ELECTRIC
CLUTCH
PULLEY
FRONT
SUSPENSION
BRACKET_
4
Loading ...
Loading ...
Loading ...