Loading ...
Loading ...
Loading ...
Setting Surface Controls (cant'd)
Models with Ceramic Glass Cooktop (cant'd)
Operating the Dual Surface Radiant Element
The cooktop is equipped with a dual radiant surface element located
at the right front (See Figure 4) position. "0 and 1_)" on the control
knob are used to indicate which coil of the dual radiant element
will heat. "0" indicates that only the inner coil will heat (Figures
1 and 2). "_)" indicates that both inner and outer coils will heat
(Figures 3 and 4). You may switch from either coil setting at any
time during cooldng.
To Operate the Dual Surface Element:
Figure 1 Figure 3 1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See
Figure 1) for smaller cookware or clod<wise (See Figure 3) for
_ _ _ larger cool<ware.
_ _ _ 3. Turn the knob to adjust the setting if needed. Start most cooking
/" '"_, operations on a higher setting and then turn to a lower setting to
finish cooldng. Each surface element provides a constant amount
_ _ s of heat at each setting. A glowing red surface heating area
Figure 2 Figure 4 extending beyond the bottom edge of the cool<ware indicates
the cool<ware is too small for the surface heating area.
4. When cooking has completed, turn the surface control knob to OFF before removing the cool<ware.
Note: The Surface Indicator light will come on when the control knob is turned on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The light may remain on even though the controls are turned OFF.
Note: See page 8, Figure 1 for recommended control settings.
To Operate Simmer Select Surface Element
The element control may be used as a normal element or as a
simmer element. The "Simmer Select" feature heats the element at
a much lower temperature than when used as a normal surface
element. You may switch between normal cooking and the Simmer
Select feature at any time during the cooking process. When using
the element control for normal cooking all of the settings on the
control knob (LO to HI) function as normal.
To Start Simmer Select:
1. Place correctly sized cool<ware on the radiant surface element.
2. Press the Simmer switch to ON located at right of the control
knob.
3. Turn the surface control knob to the desired simmer setting within
the dark band on the control knob. Use the marks as a guide
and adjust the control knob as needed (see Figure 5).
4. To return to normal cooking, press "Simmer Select" switch to OFF.
When cooking is complete, be sure to set the control knob to the
OFF position.
Figure 5
SIMMER SELECT
ON
OFF
Using Turbo Boil TM Element
The Turbo BoilTMfeature uses a higher wattage surface radiant element
which can bring food items to boil much quicker. The left front radiant
element will be clearly marked if this feature is available on your
range. If equipped with the Turbo Boil TM feature, place the cookware on
the left front surface element and follow the instructions "To Operate a
Single Radiant Element" in the Settings Surface Controls section.
',
__BoBo
Figure 6
9
Loading ...
Loading ...
Loading ...