Loading ...
Loading ...
Loading ...
SERVICING
WARNING
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur. Disconnect from
electrical supply before servicing this heater.
MAINTENANCE
For longest product life & to maintain product appearance
mount heater under cover & protect from rain & weather
whenever possible.
The exterior housing of the heater should be cleaned
regularly with a soft damp cloth. For locations near the
coast, salt in the air can cause rusting of metal. Additional
cleaning of the heater with a soft damp cloth fortnightly will
increase the life of the products appearance.
Ensure that there is no excessive build-up of dirt/dust on
the reflectors or elements as this can cause overheating
and premature element failure. To clean the reflectors and
elements, ensure heater is off and has been off for at least
2 hours after operation, and wipe off any dirt/dust with a
soft & dry cloth.
TUBE ELEMENT REPLACEMENT
!
!
WARNING
Servicing and maintenance MUST be carried out
by an authorised and licensed person only
1.Remove Front Cover of the heater by unscrewing the
3 screws holding it in place.
2.Remove first Element End Cover by unscrewing the
2 screws holding it in place.
3.Open first Element Lock Bracket by removing screw.
4.Remove outer Hex Nut, Spring Washer and Lead Wire
Ring Terminal from the threaded stud.
5.Repeat steps 2-4 to release second end of element.
6.Remove old Tube Element.
7.Assemble new Tube Element.
Hex Nut, Spring Washer and Ring Terminal must be
assembled tightly at both ends of element.
8.Element Lock Brackets and Element End Covers must
be replaced at both ends of the heater. Assemble front
cover and secure with 3 screws.
4000W & 6000W Models2000W & 3000W Models
4000W & 6000W Models2000W & 3000W Models
1.
2.
3.
4.
www.bromic.com/heating-au
14
Loading ...