Loading ...
Loading ...
Loading ...
6
B - Using the appliance for the first time
After installation, remove all notification labels (not identification or warning labels) and packaging
materials. After cleaning, make sure cleaned surfaces are thoroughly rinsed and wiped dry using
a clean, soft cloth.
NOTE: Oven will not operate unless time clock is set
The clock will require setting when you first turn on the power (or following a power failure)
See electronic control panel instructions.
Burning in
Before cooking in the appliance, an initial pre-heating is required to burn off the fine oil film used
to protect the elements during shipping. The first time you heat up the oven (or grill), the oil will
give off smoke, which is perfectly normal.
– Provide good ventilation during and after the first use at maximum temperature
operation.
Select one cooking mode and set the oven temperature to 180°C. With the oven door closed,
leave for approximately five minutes.
Repeat the above step for each cooking mode.
After completing the above, make sure all controls are turned off. The oven is now ready for
cooking and grilling.
NOTE:
On oven start up or possibly at other times, due to electricity supply deviations – the
programmer may freeze on a function – if this occurs we recommend that, after checking
other solutions without success, the power supply be disconnected from the appliance for
a few minutes, then reconnected. This may result in clearing the frozen function, allowing
you to reset the clock for normal operation.
Cooling Fan
The ovens are provided with a cooling fan motor to reduce the heat around the oven. The fan
motor is activated independently from oven temperature.
When you end the cooking program, the cooling fan will continue to operate until the oven
temperature drops below 70°C. This safeguards both the oven and the adjoining cupboards from
the possibility of temperature damage.
Safety Thermostat
Your oven is fitted with an over temperature sensor that will automatically shut down your oven
for a period if it is deemed to be overheating - this sensor is fitted to the rear wall of the oven,
inside the outer case – it will only activate in extreme circumstances and is provided as protection
to the appliance and the adjoining furnishings. If activated it will shut down the appliance for a
short time and will automatically reset allowing normal operation – you should consult your
service technician if the problem re-occurs.
TOUCH-CONTROL KEYS
The “touch-control” keys are operated by the fingers (just touching the key).When using touch
controls, it is best to use the ball of your finger rather than the tip.
Loading ...
Loading ...
Loading ...