Loading ...
Loading ...
Loading ...
References
• HandlingDiscs
• Remove the disc from its case by holding it at
the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or
To clean the disc
Wipe the disc with a soft cloth in a straight line
from center to edge.
•DO NOT use any solvent -- such as
conventional record cleaner, spray,
thinner or benzine -- to clean the disc.
•Cleaning the system
bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surface of the
disc when placing it back in its case.
• Avoid exposure to direct sunlight, temperature
extremes and nloisture.
Stains on the system should be wiped off with a soft cloth. If the
system is heavily stained, wipe it with a cloth soaked in water-
diluted neutraldetergent and wrung well, then wipe clean with a
dry cloth.
Since the system may deteriorate in quality, become damaged or
get its paint peeled off. be careful about the f'ollowing.
•DO NOT wipe it with a hard cloth.
• DO NOT wipe it strong.
• DO NOT wipe it with thinner or benzine.
• DO NOT apply any volatile substance such as insecticides to it.
• DO NOT allow any rubber or plastic to rein;fin in contact with
it for a long time.
PROBLEM POSSIBLE CAUSE SOLUTION
Powcr does not come The power cord and/or system cord is not connected. Connect the power cord and system cord conTectly.
on. (-'pg. 13)
'll_e remote control does The batteries are exhausted. Replace the batteries. (_-"pg. 6)
not work. Sunlight is lidling directly on the remote sensor. Hide the remote sensor from direct sunlight.
No sound. The system cord and/or speaker cord is not connected. Check the connection.
l'he audio cord is not connected to AUDIO IN (VCR) Connect the cord correctly. (7" pg. 13)
and/or DIGITAL IN (DBS) correctly.
An incorrect source has been selected. Select the correct source. (: -"pg. 17)
The decode mode is not set correctly. Select the proper decode mode. (_ pg. 35)
No picture is displayed The video cord is not connected correctly. Connect the cord colzectly. (_-"pg. 12)
on the TV screen. The disc is not playable. Use a playable disc. (7" pg. 3)
No picture is displayed 'll_e scan mode is set to "PROGRESS" though the Change the scan mode to "INI:LACE '', (7" pg. 18)
on the TV screen, the center unit is connected to the TV which does not
picture is blun'ed, or the support the progressive video input such as a
picture is divided into conventional TV.
two pm-ts.
Video and audio are The disc is scratched or dirty. Replace or clean the disc.
distorted. A VCR is connected between the center unit and the Connect the center unit and TV directly. (v" pg. 12)
TV.
l'he picture does not fit l'he monitor type is not set con'ectly. Set "MONITOR TYPE" properly. (7" pg. 37)
the TV screen.
Hard to listen to Antennas are disconnected. Reconnect the antennas con'ectly and securely.
broadcast because of (7" pg. 7)
noise.
42
Loading ...
Loading ...
Loading ...