Loading ...
Loading ...
Loading ...
360 IN CASE OF EMERGENCY
NOTE:
Ensure that the jack and tool bracket assembly slides into
the front hold down location.
4. Turn the wing bolt clockwise to secure to the floor
pan. Reinstall the plastic cover.
Wing Bolt/Jack And Tools
HUB CAPS/WHEEL COVERS —
I
F EQUIPPED
The hub caps must be removed before raising the vehicle
off the ground.
For 2500/3500 Single Rear Wheel (SRW) models, use the
flat end of the lug wrench to hook and pull off the hub cap.
Find the opening in the hub cap, insert the lug wrench, and
pull off the cap. If you need to pry against the wheel,
protect the wheel surface.
Lug Wrench Insertion Location — Hub Cap
On 3500 models with Dual Rear Wheels (DRW), you must
first remove the hub caps—use the procedure noted for
the single rear wheel. For the wheel covers (wheel skins),
insert the flat end of the lug wrench between the outer
edge of the wheel cover and the wheel. Pry against the
wheel to remove the wheel cover. Repeat this procedure
around the wheel until the cover pops off.
Lug Wrench Insertion Location — Wheel Cover
Replace the wheel covers using a rubber mallet to ease
the installation. Align the wheel cover vent holes to the
wheel vent holes. Tap on the wheel cover as needed to
firmly seat it evenly around the wheel.
CAUTION!
Use extreme caution when removing the front and rear
wheel covers. Damage can occur to the center cap
and/or the wheel if screwdriver type tools are used. A
pulling motion, not a pry off motion, is recommended to
remove the caps.
CAUTION!
Use a pulling motion to remove the hub cap. Do not
use a twisting motion when removing the hub cap,
damage to the hub cap; finish may occur.
The rear hub caps on the dual rear wheel has two pull
off notches. Make sure that the hook of the jack
handle driver is located squarely in the cap notch
before attempting to pull off.
23_DJD2_OM_EN_USC_t.book Page 360
Loading ...
Loading ...
Loading ...