Loading ...
Loading ...
INTRODUCTION
ASSEMBLY
Unpack your dovetail template, separating and
removing all loose parts from the packaging
materials. Check each item with the "Table of Loose
Parts" to make sure all items listed have been pack
ed with your dovetail template. See Figure 1.
ASSEMBLE YOUR DOVETAIL
TEMPLATE AS FOLLOWS:
1. Insert hex bolts through holes in your dovetail
base and tit into molded slots on bottom side of
base.
2. Secure hex bolt with push nuts supplied. See
Figure 1.
3. Place one spring over each hex bolt.
4. Place a washer on top of each spring, then install
clamp bar on top of washer. NOTE: For proper
assembly, be sure to turn each clamp bar as
shown in Figure 1.
5. Place a second washer on top and/or end of each
clamp bar.
6. Thread wing nut onto each hex bolt to secure
washers, clamp bars, and springs.
Item No.
1
2
3
4
5
6
7
8
9
10
TABLE OF LOOSE PARTS
Description Quantity
Dovetail Template ........................ 1
Hex Bolt (#1/4-20 x 2-7/8") ................. 4
Push Nut ................................ 4
Spring .................................. 4
Washer ................................. 8
Clamp Bar ............................. 2
Wing Nut ................................
5/16" Guide Bushing...., .................. 1
7/16" Guide Bushing ...................... 1
Screw (10o32 x 1/2" Flat Head) .............. 3
Your dovetail template has been designed for cut-
ting flush, offset, or rabbeted joints with speed and
accuracy. See Figures 2, 3, & 4. Since these joints
are both strong and neat, they are commonly used
when making drawers and boxes.
Read atl instructions carefully, and follow closely
while making set ups and adjustments. ONCE ALL
ADJUSTMENTS HAVE BEEN PROPERLY MADE,
MAKE A TRIAL CUT WITH SCRAP PIECES OF THE
SAME WOOD USED FOR THE FINISHED WORK.
This step allows you to check your adjustments, it
also makes you aware of the characteristics of the
particular wood being used,
TOOLS NEEDED
In addition to your dovetail template and guide
bushing, you will also need a Craftsman Rouler and
a dovetail cutter. Use dovetail cutter Catalog
Number 26319 for making 1/4 inch dovetail joints
and Catalog Number 26318 for making 1/2 inch
joints.
FLUSH JOINT Fig.2 OFFSET JOnNT
Fig, 3
Page 3
Loading ...
Loading ...
Loading ...