Loading ...
Loading ...
Loading ...
Troubleshooting en
27
Fault Cause and troubleshooting
LED lit up despite
water tank being full.
Carbonated water is in the water tank.
▶ Fill the water tank with fresh tap water.
Float is stuck in the water tank.
1. Remove the water tank.
2. Clean the water tank thoroughly.
New water filter was not rinsed as per instructions.
1. Rinse the water filter according to the instructions.
2. Place the water filter into operation.
Air is in the water filter.
1. Immerse the water filter in water with the opening
facing upwards until no more air bubbles escape.
2. Reinsert the filter.
Water filter is old.
▶ Insert a new water filter.
Limescale deposits in the water tank are blocking the
system.
1. Clean the water tank thoroughly.
2. Start the Calc'nClean service programme.
All LEDs flashing. There are problems with the power supply.
▶ Only operate the appliance at 220-240V.
LED ap-
pears very frequently.
Decalcified water still contains small amounts of lime.
1. Insert a new water filter.
2. Set the corresponding water hardness.
Incorrect or too little descaling agent used.
▶ When descaling, only use suitable tablets.
Appliance cannot be
operated.
LEDs light up or flash.
Appliance is in demo mode.
1. To deactivate demo mode, press and hold the
button for at least 5 seconds.
2. Remove the water tank.
3. Fill the water tank with fresh water.
4. Re-insert the water tank.
LED flashes.
Door is not properly closed.
▶ Press the door firmly shut.
Appliance is too hot.
1. Disconnect the appliance from the mains.
2. Wait 1hour so the appliance can cool down.
Loading ...
Loading ...
Loading ...