Loading ...
Loading ...
Loading ...
18
1. Lift out and remove the Wok Ring, Sleeve and
Chimney from the appliance. Note front of Wok
Ring.
2. Unscrew the gas supply pipe to the main burner.
3. Remove the 2 screws securing the main burner
and lift out the main burner.
4. Replace with correct main burner for gas type
being used. Refer to Gas Specifications Table.
5. Refit Wok Ring, Sleeve and Chimney, ensure they
are correctly located onto the burner frame.
1. Unscrew and remove the
blanking screw at base of
the pilot burner assembly.
2. Remove the pilot injector
and spring, taking care not
to lose the spring.
3. Fit the spring to the
replacement pilot injector
and using a small flat
bladed screwdriver, screw
the pilot injector fully home.
4. Light the pilot burner and
ensure the flame is the
correct size.
5. Turn ‘Off’ pilot burner and
refit the blanking screw to
the base of the pilot
assembly.
6. On completion, refit the Pilot Shield to the Pilot
Bracket, (this is a push-fit onto the pilot bracket).
Wok Ring
Wok Chimney
Front of Wok Ring
NOTE:
It is critical that when re-fitting the pilot burner, the
pilot burner is correctly orientated in the pilot
bracket as shown below so that the pilot flame
strikes the thermocouple and also ignites the main
burner otherwise the pilot burner will not operate
correctly.
On completion of gas conversion, replace gas type
labels located at:-
- Rear of unit, above the gas connection.
- Beside the rating plate.
Before leaving the installation;
1. Check all gas connections, including the pilot
burner injector base connection, for leakage
using soapy water or other gas detecting
equipment.
2. Carry out a ‘Commissioning’ check of the
appliance as shown in Installation Section of this
manual.
3. Ensure any adjustments done to components
that have adjustments / settings paint sealed,
these are to be re-sealed.
NOTE:
If it is not possible to get the appliance to operate
correctly, shut ‘Off’ gas supply and contact supplier
of this appliance.
Duckbill Burner
Chimney Burner
Remove
2 Screws
Disconnect Main
Burner Gas Pipe
DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.
Pilot
Burner
Pilot
Injector
Blanking
Screw
Injector
Spring
Injector
Body
Loading ...
Loading ...
Loading ...