Broan B98DHV Installation & Operation Instructions

Loading ...

Installation & Operation Instructions 800.558.1711

The Dehumidier plugs into a common grounded 115 VAC outlet. Locate the dehumidier in an area where the

cord’s length (9') easily reaches a 115 VAC electrical outlet with a minimum of 15 Amp circuit capacity. If used

in an area that may become wet, a GFCI protected circuit is recommended. Consult local electrical codes for

further information.

A variety of control devices can be used with this dehumidier. The control is to be located remotely from the

dehumidier and placed in the space to be conditioned. A low voltage (24 Volt) control MUST be used with the

Dehumidier and MUST be connected with low voltage (18-22 gauge) thermostat wire.

ELECTRICAL REQUIREMENTS

CAUTION!CAUTION!

DO NOT ALLOW THE 24V TERMINAL TO CONTACT THE COM/DMPR TERMINALS ON THE

DEHUMIDIFIER OR DAMAGE TO THE TRANSFORMER WILL RESULT.

Electrical Precautions

• Do not install the control where it may not accurately sense the relative humidity such as near HVAC

supply registers, near exterior doors, on an outside wall, near a window, or near a water source.

• The screw terminals on the Dehumidier and the control are labeled to prevent confusion.

• Be sure to consult the electrical schematic in the CONTROLS Section (page 12) of this manual or inside

the access panel of the Dehumidier before making control connections.

WARNING!WARNING!

THE REMOTE CONTROLS OF THE DEHUMIDIFIER ARE POWERED BY A LOW VOLTAGE CIRCUIT (24

VAC) AND MUST NEVER CONTACT OR BE CONNECTED TO A HIGH VOLTAGE CIRCUIT.

CAUTION!CAUTION!

SOME OF THE SCREW TERMINALS ON THE DEHUMIDIFIER MAY NOT BE USED WITH CERTAIN

CONTROLS AND SHOULD BE LEFT UNCONNECTED.

B98DHV Wiring Diagram B120DHV Wiring Diagram

Loading ...

Broan B98DHV 98 Pint Dehumidifier