Loading ...
Loading ...
Loading ...
4.3.2 Object avoidance
Object avoidance
is only available for Automower
®
430X/450X NERA.
The products senses objects on the lawn that is higher
than the grass with the
Object avoidance
function
enabled. When the product senses an object on the
lawn, the product turns and continues to cut in a
different direction. You can disable the
Object avoidance
function if it is unsatisfactory for your work area.
Note:
Object avoidance
can cause that the grass is
not cut around objects. The sensors can also sense high
grass or flowers in the work area as objects.
4.3.3 Weather timer
Weather timer
automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
When using
Weather timer
, it is recommended
to make as much operating time as possible available
for
Weather timer
. Do not restrict the schedule more
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
and then
Weather timer
selects if the product will
continue to operate or not.
Note:
Weather timer
is reset if the product does not
operate for more than 50 hours, or if a
Reset of all user
settings
is done.
Weather timer
is not changed if a
Reset
of schedule settings
is done.
4.3.4 ECO mode
ECO mode
disables the signal in the boundary wire,
guide wire and the charging station, when the product is
parked or is charging. The LED indicator of the charging
station flashes green when the loop signal is disabled.
Note:
Use
ECO mode
to save energy and to prevent
interference with other equipment, for example hearing
loops or garage doors.
Note: To start the product manually in the work area
you must first enable the loop signal.
4.3.4.1 To enable the loop signal
1. Set the product to ON.
2. Push the STOP button.
3. Wait 2 seconds and then remove the product from
the charging station.
4. Make sure that the LED indicator of the charging
station is solid green.
5. Put the product where you want it to start to cut.
4.4 Installation
In
Installation
you can change the installation settings of
the product.
4.4.1 To find the charging station
The product can be set to search for the charging station
in 3 methods:
•
Charging station signal
•
Follow boundary wire
•
Follow guide wire
The factory setting is set to use the 3 search methods
at the same time. Use the factory setting to find the
charging station as fast as possible and to keep the risk
of tracks on the lawn to a minimum. The product always
starts to search for the
Charging station signal
. After
a specified time interval, it also uses
Follow guide
and
Follow boundary wire
.
Causes why the product cannot follow the wire:
• Obstacles near the wire have not been isolated.
• The charging station, the boundary wire or the
guide wire are not installed according to the
instructions in
To install the charging station on
page 17
,
To install the boundary wire on page 18
and in
To install the guide wire on page 18
.
4.4.1.1 Charging station signal
For some installations it is necessary to decrease the
signal of the charging station. For example when the
charging station is put near an obstacle, such as a bush
or a wall. The product finds the charging station signal
on the other side of the obstacle and tries to find the
charging station, but the object prevents it to go to the
2071 - 001 - 29.03.2023
Settings - 21
Loading ...
Loading ...
Loading ...