Loading ...
Loading ...
Loading ...
15
E - Trouble Shooting Guide
F - Installation instructions.
INFORMATION FOR THE INSTALLER
THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN.
WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE
TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS.
DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN
WARNING:
Installation must comply with Standards North America (within North America) wiring rules, as
well as your local electrical and building codes and regulations, and any other applicable
requirements. Your appliance must be properly installed and grounded by a qualified and
licensed technician.
Incorrect installation of the appliance, resulting from the kitchen contractor not following the
detailed installation specifications, can affect the appliance performance. Ovens incorrectly
installed may invalidate the warranty and we strongly recommend that the oven cavity and
venting be prepared, as described, in the following specifications. This is critical to appearance,
oven performance, and safety.
Measurements
Please note that all dimensions provided are in millimeters (mm.). The sizes allow for only a small
degree of error so all cut-outs must be precise and square. To ensure the cabinet is well finished,
the cut edges must also be square and care must be taken to ensure the cut edges are free of
chips.
Symptom
Remedy
No power supplied to appliance
Has the power been disconnected? Check the meter
box. Has the main fuse or circuit breaker blown or
tripped?
Oven power is on but appliance does not
operate
Oven may be set on AUTO (see auto programmed
cooking).
Oven power is on but there is no heat
Oven may be set on AUTO.
Oven temperature may be set OFF.
Mode may be on incorrect selection.
Rubber seal has gap(s) at bottom and
ends do not meet
Correct - doors are sealed this way for oven venting
purposes.
Display is flashing, is only part illuminated
or is cycling through various displays.
Turn power supply to appliance off, wait 30 seconds and
turn power on. Reset clock.
Loading ...
Loading ...
Loading ...