Loading ...
Loading ...
Loading ...
17
When you have installed the cooktop, make sure that
• the power supply cable is not accessible through cupboard doors or drawers.
• there is adequate flow of air from outside the cabinetry to the base of the cooktop.
• if the cooktop is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the cooktop.
• the isolating switch is easily accessible by the customer.
Cautions
1. The cooktop must be installed by qualified personnel or technicians. Please never
conduct the operation by yourself.
2. The cooktop shall not be wired on the same circuit as cooling equipment,
dishwashers, and rotary dryers.
3. The cooktop shall be installed with adequate ventilation to enhance its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat and
be nonflammable.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
7. This cooktop can be connected only to a supply with system impedance no more
than 0.427 ohm. In case necessary, please consult your supply authority for system
impedance information.
Connecting the cooktop to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown as the diagram.
EMCER64E
This cooktop must be connected to the mains power supply only by a suitably qualified
person. Before connecting the cooktop to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the cooktop.
2. The voltage corresponds to the value given in the rating plate
3. The power supply cable sections can withstand the load specified on the rating plate.
Loading ...
Loading ...
Loading ...