Loading ...
Loading ...
Loading ...
29
CARE AND MAINTENANCE
Cleaning Main Burner
--------------------------------------------------------------------------------
To prevent Flash backs and good performance of burner, the procedure below should be followed at
least once a month in late summer or early fall when spiders are most active or when your grill has
not been used for a period of time:
1. Turn off at control knobs and LP cylinder.
2. Remove cooking grates and ame tamers
3. Remove cotter pins from rear of burners. Detach ignition wire from the ignition pin by hand only. DO NOT
use tool. Then Lift burner slowly.
4. Check all burner ports are clear of clogs. Use of
a pin or paper clip works well.
5. Ensure the end of the burner and primary
air screen are clear from insect nests, dirt or
debris. Using a bent stiff wire in the shape of a hook , or a bottle brush, run it through the burner tube and
inside several times to remove any debris.
6. Inspect each burner for damage (cracks or holes) and if such damage is found, order and install a new
burner.
Re-Installing Main Burners
-----------------------------------------------------------------------------------
Ensure the gas valve orices must be correctly positioned inside the burner tube. If the burner tube
does not t over the valve orice, lighting the burner may cause explosion and/or re.
It is recommended to use a ashlight to view the correct position through the rebox vent holes as
illustrated below.
After checking , reattach each burner with the cotter pins and reattach the ignition wire to the ignition
pin by hand.
Wrong
Wrong
Correct
View the correct position
from the bottom of the firebox
Loading ...
Loading ...