Loading ...
Loading ...
Loading ...
WARNING
If converting from a 4-wire electrical system to a 3-wire, the ground strap
must be reconnected to the terminal block support to ground the dryer
frame to the neutral conductor. Ring-type terminals are recommended.
Ifusing strap terminals, make sure they are tightened.
24
CONNECT THE ELECTRICAL WIRING
Review the “Electric Requirements” section on page 16.
BEFORE OPERATING OR TESTING, follow the grounding instructions in
the “Grounding” section on page 18.
THREE WIRE OUTLET
If your outlet is a three-wire outlet, choose a 3-wire
power supply cord with ring or spade terminals and UL
listed strain relief. The 3-wire power supply cord must:
• Beat least 4 ft. (1.22 m) long.
• Have three 10-gauge solid copper wires.
• Match a three-wire receptacle of NEMA Type 10-30R.
3-Wire system connections
1. Remove the center terminal block screw.
2. Connect the neutral wire (white or center wire) of the power cord to
the center terminal screw of the terminal block. Be sure to cross the
screw through the ring of the power cord terminal and tighten the
screw.
3. Connect the other wires to the outer terminal block screws. Be sure
to cross the screw through the terminal ring and tighten the screw.
4. Tighten the strain relief screws.
5. Insert the tab of the terminal block cover into your dryer’s rear panel
slot. Secure the cover with a screw.
3-wire system instructions:
A Center terminal block screw
B External ground connector
C Neutral grounding wire (White)
D Neutral wire (white or center wire)
E 3/4" (1.9cm) UL-listed strain relief
3-Wire
receptacle
(10-30R)
Dryer
Safety
Operation
Requirements
Parts and
Features
Installation
Instructions
Dryer Care
Troubleshooting AppendixDryer Use
A
B
C
D
E
Loading ...
Loading ...
Loading ...