Loading ...
Loading ...
Loading ...
Open
Nipple Flexible
Connector
Inlet Pipe on
Back of Dryer
WARNING
•
All gas installations of the dryer must be equipped with Manual
Shut-O valve.
•
Uncoated copper tubing will corrode when subjected to natural gas,
causing gas leaks. Use ONLY black iron, stainless steel, or plastic-
coated brass piping for gas supply.
•
Check all gas connections for leaks using a soap solution.
•
If bubbles appear, tighten the connections and recheck. DO NOT
use an open flame to check for gas leaks.
CONNECT THE GAS LINE (FOR GAS MODELS)
Review the “Gas Requirements” section on page 14. Remove the pipe
thread protective cap.
Apply a pipe joint compound or about 11/2" wraps of teflon tape over all
threaded connections.
•
The pipe joint compound must be resistant to the actions of any
liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required to
connect the 3/4" (1.9 cm) female thread end of a flexible connector to the
3/8" (1 cm) male threaded end on the dryer. Use only new AGA or CSA
certified gas supply line with SS flexible connectors. The National Fuel Gas
Code requires that an accessible, approved manual gas shuto valve be
installed within 6 in. (15 cm) of your dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
Manual
Shutoff
Valve
Flare
Union
GAS FLOW
Flare
Union
All connections must be wrench-tightened
23
Dryer
Safety
Operation
Requirements
Parts and
Features
Installation
Instructions
Dryer Care
Troubleshooting AppendixDryer Use
Loading ...
Loading ...
Loading ...