Loading ...
Loading ...
Loading ...
PAGE 7
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause damage to motor.
FIGURE 19
FIGURE 16
FIGURE 17
FIGURE 18
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
30. After cleaning, replace
inlet shield and foam pad
and secure with screws.
NOTE: Inlet shield will
only fit properly one way
FIGURE 16.
BLOWER OPERATION
31. The correct operating
position is to hold the portable
blower in either hand, at
arms length at your side. Your
portable blower has been
designed with the necessary
angle to direct the air blast
toward the ground in front of
you.
FIGURE 17.
CAUTION: DO NOT OPERATE
BLOWER WITHOUT INLET SHIELD AND
FOAM IN PLACE.
36. Your portable blower can be used for:
a. Cleaning grass from walkways
after mowing or edging
b. Sweeping or drying patios
c. Cleaning driveways
d. Sweeping out garages and
workshops equipment
e. Blowing out flower beds
f. Leaf control in autumn
g. Cobweb removal
h. Overhead sweeping
i. Dusting of hard-to-clean equipment
j. Cleaning shelves and workbenches
37. Reattach portable blower
for wet/dry operation by
placing power unit back
into tank cover pushing in a
downward motion until detents
engage FIGURE 18.
WARNING:
32. Always work going away from solid objects such as
walls, large stones, automobiles and fences.
33. Clean spaces with corners by starting in corners
and moving outward to open areas to prevent an
accumulation of debris which could fly into your face.
34. Be careful when working near valuable plants. The
force of the air could damage tender plants.
35. Use both handles when working above the waist or
when two-handed grip is desired.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
38. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When pick-
ing up fine dust or powders a high efficiency filter bag
(not standard with all models) must be used with
the cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
39. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 19.
ALWAYS WEAR EYE
PROTECTION TO PREVENT
ROCKS AND DEBRIS
FROM BEING BLOWN OR
RICOCHETING INTO THE EYES OR FACE WHICH
CAN RESULT IN SERIOUS INJURY.
Loading ...
Loading ...
Loading ...