Loading ...
Loading ...
Loading ...
13. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
14. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 11.
15. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 11.
PORTABLE BLOWER
OPERATION
FIGURE 11
Questions?
U.S. Customers call 888-822-4644
or visit www.shopvac.com 24 hours a day.
Canadian Customers call 905-335-9730
or visit www.shopvac.ca 24 hours a day.
12. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
16. Plug the cord into the wall outlet. Your cleaner
is ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or the Shop-Vac
®
website.
FIGURE 12
FIGURE 13
FIGURE 15
BLOWER SAFETY
17. Never operate the portable blower in wet or damp
conditions. Do not use in rain.
18. Keep area of operation clear of all persons,
particularly small children and pets.
19. Dress properly. Do not wear loose clothing or
jewelry. Always wear substantial footwear and long
pants. Secure loose hair with a hat or hair net to avoid
hair being caught in moving parts.
20. Never blow debris in direction of bystanders.
21. Do not overreach or use blower from unstable
surface such as ladders, trees, steep slopes, roof tops,
etc. Always be sure of your footing.
ASSEMBLY INSTRUCTIONS
25. To remove portable blower
from tank cover, grasp both
blower handles and pull in an
upward motion. FIGURE 12.
A
B
C
26. Insert 2-1/2” extension wand (B) into the blower
exhaust (A). Push firmly into place by twisting wand
slightly. Attach desired accessory (C). FIGURE 13.
27. Plug the cord into
an electrical outlet. Your
portable blower is ready
for use. NOTE: If an
extension cord is used,
use only an approved
outdoor extension cord.
To prevent extension cord from pulling away from
appliance cord, tie cords as shown. FIGURE 14.
28. To clean inlet shield and
foam pad, disconnect cord from
receptacle and remove screws
on bottom side of power unit.
FIGURE 15.
29. Once removed, run foam pad under running water
and blot with clean towel to dry.
22. Inspect the area before using the blower. Remove all
debris and hard objects such as rocks, glass, wire, etc.
that can be blown or cause damage during operation.
23. Always wear a respirator or face mask when working
in dusty environments.
24. Keep vents clean and clear of dirt and debris.
FIGURE 14
PAGE 6
Loading ...
Loading ...
Loading ...