Loading ...
Loading ...
Loading ...
Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.
UNPACKING
ASSEMBLY
CASTER SYSTEM
ASSEMBLY
TOOL HOLDER
ASSEMBLY
11. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
GENERAL SET UP
PAGE 5
You will find four caster feet
FIGURE 1, four casters
FIGURE 2, four screws, and
four washers with your wet/dry
vacuum. Assemble as follows:
1. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that the
bottom is facing up.
A
A
A
A
2. With tank drain facing you,
take caster feet marked with
letter A and place in slots on
left front and right rear of tank
also marked with the letter A.
FIGURE 3.
B
3. Secure with screws
provided. FIGURE 4.
B
B
B
B
A
A
4. Take caster feet marked
with the letter B and place on
right front and left rear of tank
also marked with the letter B.
FIGURE 5.
5. Secure with screws provided.
FIGURE 6.
6. Take flat washer and place
over stem of caster.Insert
casters into feet by placing
stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place. FIGURE 7.
7. Return tank to upright position.
FIGURE 1
FIGURE 2
FIGURE 6
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 7
FIGURE 3
FIGURE 4
FIGURE 5
8. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 8.
9. Place “J” shaped tabs
into the slots on cord wraps.
FIGURE 9. Press down until
tabs snap into place.
10. Press down on center of
tool holder until tab latches on
bottom of lid.
FIGURE 10.
Loading ...
Loading ...
Loading ...