Loading ...
Loading ...
Loading ...
14
Place the engine on a level surface with engine stopped. Check the engine oil level. Remove the oil
maintenance cover. Remove the dipstick and wipe it clean.
Reinstall dipstick into hole, rest on oil fill neck, DO NOT thread cap into hole.
Remove the dipstick again and check oil level. Level should be between the upper and lower limit.
Fill to the upper limit of the dipstick with the recommended oil if the oil level is too low.
Reinstall and fully tighten the dipstick.
CAUTION: Operate generator only on a level surfaces. The engine is equipped with a low oil sensor
(applicable types) that will automatic stop the engine when the oil level falls below the safe limit. To
avoid the inconvenient of an unexpected shutdown, fill to the upper limit and check the oil level
regularly.
4. Generating set fuel check
WARNING: This generator may emit highly flammable and explosive gasoline vapors,
which can cause severe burns or even death if ignited. A nearby open flame can lead to
explosion even if not directly in contact with gasoline.
With the engine stopped, check the fuel level. Refill the fuel tank if necessary. Use clean, fresh, regular
unleaded gasoline with a minimum octane rating of 87. Do not mix oil with gasoline. Always wipe up any
spilled fuel.
To add gasoline, follow these steps:
1. Make sure the generator stopped and it is on a level surface.
2. Unscrew fuel cap and set aside.
NOTE: The fuel cap may be tight and hard to unscrew.
3. Slowly add unleaded gasoline to the fuel tank. Be sure not to fill above
the upper limit mark. Always allow room for fuel expansion. The
capacity of the fuel tank is 2.06 gallons .
NOTE: Do not fill the fuel tank to the very top. Gasoline will expand
and spill over during use even with the fuel cap in place.
4. Reinstall fuel cap and wipe clean any spilled gasoline with a dry cloth.
Loading ...
Loading ...
Loading ...