Loading ...
Loading ...
Loading ...
12
Fuel tank cap
Remove the fuel tank cap by rotating it anticlockwise.
Telescoping handle
When moving the generator, please hold the telescoping handle and press the button on it, and pull it
outward.
Note: Before moving, please turn off the generator and fuel switch. Please move the generator on a
relatively flat ground. Do not perform the movement on a surface where the pit exceeds 40mm.
GENERATOR PREPARATION
The following section describes steps necessary to prepare the generator for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the generator or shorten its
lifespan.
Unpacking
Unpack the generator and all its parts. Do not discard the carton or any packaging until the generator is
completely assembled.
1. Operating Location
Only use OUTSIDE and place the generating set in a well-ventilated area.
Only operate the generating set on a flat, level surface and in a clean, dry operating environment.
Allow two feet clearance on all side of the generating set while operating it outdoors.
Operate in specified area, if any problem on applicable occasion, please consult the authorized local
dealers. In some areas, generating set must be registered with the local utility. Generating set used to
construction sites may be subject to additional rules and regulations.
DANGER: The exhaust of the generating set contains carbon monoxide, using engine indoors
CAN KILL YOU! NEVER use inside any building or any kind of enclosure, EVEN IF doors
and windows are open. Place the generating set in a well-ventilated and clean area. Note the wind
direction and air current when place the generating set.
Loading ...
Loading ...
Loading ...