Loading ...
Loading ...
Loading ...
Questions? Call Toll Free at 1-800-737-2112 Copyright © 2019 MAT Engine Technologies, LLC
ENG - 8
Assembly (Continued)
• Save all instructions
Wheel Assembly
B
1. Install the wheels to the frame using the provided hex
screws and washers. Install one washer on the inside
and one washer on the outside of each wheel.
Tighten to 9-13 ft. lbs. (12-18 Nm) torque using a
12 mm wrench. (Fig. 4)
1. Install the tube end of the blower assembly
into the engine clutch housing. It may be necessary
to rotate the blower assembly slightly to align the shafts.
Rotate the installed tube so the index screw opening
in the housing matches the hole in the blower assembly
tube. Install the socket head screw (M6 x 12) with the
provided hex wrench. Tighten securely. (Fig. 5)
2. Set the unit on a flat hard surface. The swivel wheel
should sit flat and perpendicular to the surface. Tighten
the clamp screw (M6 x 25) securely. Try to rotate the
tube within the housing. If you can rotate the tube,
tighten the clamp screw additionally. Repeat if
necessary. (Fig. 5 & 6)
1. Push discharge nozzle onto the Blower housing
outlet. (Fig. 7 )
2. Rotate nozzle so it discharges slightly towards the
front. (Fig. 8)
3. Hand tighten the wing knob to lock into position.
Do not operate the Blower without the discharge
nozzle assembled.
Blower Assembly
C
Discharge Nozzle Assembly
D
WARNING
Loading ...
Loading ...
Loading ...