Loading ...
Loading ...
Loading ...
INSTALLING YOUR FREESTANDING COOKER
11
GAS CONNECTION
WARNING: Before starting any work related with gas installation, turn off gas supply.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push on the hose until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control panel are closed, but the gas cylinder
is open. Apply some soap bubbles to the connection. If there is gas leakage, there will be foaming in
the soaped area.
3. The oven should be using a well ventilation place and should be installed on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter
level by adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through the heated areas, especially
through the rear side of the oven. Do not move gas connected oven. Since the forcing shall loosen
the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
FOR LPG CONNECTION
FOR NATURAL GAS CONNECTION
CHANGING THE NOZZLES FOR LPG USE
To change the burner nozzles, use a size 7
socket wrench. Remove the nozzle from the
burner and install the new one.
For LPG (cylinder) connection, affix metal clamp on the hose coming
from LPG cylinder. Affix an edge of the hose on hose inlet connector
behind the appliance by pushing to end through heating the hose in
boiled water. Afterward, bring the clamp towards end section of the
hose and tighten it with screwdriver. The gasket and hose inlet
connector required for connection is as the picture shown below.
NOTE: The regulator to be affixed on LPG cylinder should have 300
mmSS feature.
WARNING: Natural gas connection should be done by
authorized service. For natural gas connection, place
gasket in the nut at the edge of natural gas connection
hose. To install the hose on main gas pipe, turn the nut.
Complete the connection by making gas leakage control.
Loading ...
Loading ...
Loading ...