Loading ...
Loading ...
Loading ...
2
POSITIONING TABLE AND WORKPIECE
Lock the table to the column in a position so that the
tip of the drill is just a little above the top of the work-
piece.
Always place a piece of BACK-UP MATERIAL (wood,
plywood...) on the table underneath the workpiece.
This will prevent "splintering" or making a heavy burr
on the underside on the workpiece as the drill breaks
through. To keep the backup material from spinning
out of control, it must contact the left side of the column,
as illustrated.
WARNING: To prevent the workpiece or the backup
material from being torn from your hand while drill-
ing, position them against the left side of the col-
umn. if the workpiece or the backup material are
not long enough to reach the column, clamp them
to the table. Failure to do this could result in per-
sonal injury.
WORKPIECE BACK-UP
MATERIAL
For small pieces that cannot be clamped to the table,
use a drill press vise (Optional accessory).
WARNING: The vise must be clamped or bolted to
the table to avoid injury from spinning work and
vise or tool breakage,
WORKPIECE
DRILL PRESS
VISE
TILTING TABLE
To use the table in a bevel (tilted) position, loosen the
set screw under table bevel lock with set screw wrench.
Loosen bevel lock with adjustable wrench.
Tilt table to desired angle by reading bevel scale. Re-
tighten bevel lock and set screw.
19
Loading ...
Loading ...
Loading ...