Loading ...
Loading ...
Loading ...
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit
the ends of the red cable against the
chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.
To remove the jumper cables
Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Tire pressure
The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To remove the mulch plug
You find the mulch plug on the bottom side of the cutting
deck.
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 12
.
2. Remove the screw that holds the mulch plug and
remove the mulch plug.
3. Put the cutting deck in mow position.
4. Attach the mulch plug in the opposite sequence.
To examine the blades
CAUTION: Damaged or incorrectly
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 12
.
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
3. Tighten the blade bolts with tightening torque Nm.
To replace the blades
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 12
.
2. Lock the blade with a wooden block (A).
A
C
D
B
1466 - 006 - 17.04.2023
25
Loading ...
Loading ...
Loading ...