Loading ...
Loading ...
Loading ...
2. Put the throttle control in position (A).
A
B
C
a) For R 112C, R 115C, let the engine idle for a
minimum of 30 seconds.
b) For R 112C5, put the gearshift lever in the
neutral position (N).
N
3. Turn the ignition key to the STOP position.
4. When the product stops, apply the parking brake.
To apply and release the parking brake
R 112C, R 115C has the parking brake pedal and the
lock button for the parking brake on the left side. R
112C5 has the parking brake pedal and the lock button
for the parking brake on the right side.
1. Press the parking brake pedal down (A).
2. Press and hold the lock button (B).
A A
BB
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.
To get a good result
• Do not cut a wet lawn. Wet grass can give a bad
result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (for highest
permitted motor speed, refer to
Technical data on
page 31
). Move the product forward at low speed.
If the grass is not too high and thick, you can get a
good result also at a higher speed.
• To get the best result, cut the grass frequently and
use the mulch function. Refer to
To remove the
mulch plug on page 25
.
Maintenance
Introduction
WARNING: Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
1466 - 006 - 17.04.2023 17
Loading ...
Loading ...
Loading ...