P1 P2 P3P4
How to install wall mount
2) Use 2 screws to fix the bottom plate
to the hanger.
Before installing the charger on the
hanger, you can directly insert the charger
into the charging hole to charge the whole
machine or single host, or charge the
removed battery pack separately.
When the charger is installed on the wall
mount, you can place the whole unit or a
single battery pack into the mount for
charging.
Installation and use of wall mount
1) Drill holes approximately 58 inches
above the ground.
1) Insert the charger head into the
corresponding slot in the hanger, and
place the cable into the side slot.
2) Insert the vacuum or battery pack
into the wall mount from above. Insert
the accessories into the sides of the
wall mount from the bottom until you
hear a click.
1. Assemble the desired attachments.
2. Press and hold the power button for about three seconds to turn
on the appliance. It will then enter a medium-power mode.
3. Touch ( , ) on screen to adjust the power. There are three
levels: high, medium and low. Touch ( ) on screen to turn on
auto speed and dust indicator feature.
When it's in AUTO mode, the vacuum will adjust its speed according
to the dust on the floor. If there is a lot of dust, the vacuum will turn
to high speed by itself. If there is less dust, the vacuum will turn to
normal or slow speed and run for longer.
4. Press the power button again to turn off the appliance.
ATTENTION: The floor brush may be blocked on long pile carpets. This
vacuum has a protection program to make the vacuum stop working when
the floor brush is blocked. If the vacuum stops working on long pile carpets,
please restart the machine by turning it back on.
Quick Start Guide
Ultimate Series
Stick Vacuum cleaner
Press the Power button to turn
the machine on and off
Touch (-,+) on screen to
adjust the suction power.
A. Charging indicator
B. Floor brush rotor locking indicator
C. Reduce Suction
D. AUTO Switch
E. Suction indicator
F. Increase Suction
G. Over temperature protection indicator
H. Clogging indicator
I. Remaining battery display
J. Suction atmosphere light
K. Charger error indicator
Charging indicator: The blinking green light indicates the battery is charging.
When fully charged, the green light is always on, Battery shows 100%.
Suction plus and minus button: Use the – and + to toggle between the
Auto button: The vacuum starts in manual mode and the auto button will be
white. When you press the Auto button it will turn blue and enter auto mode.
different power modes.
Waste disposal indicator: It will display E7 when the motor is no-Ioad, which
means the air duct needs to be cleaned.
Floor brush rotor locking indicator: When the floor brush is blocked, this
indicator will light up. Check the floor brush for any debris and clean it out.
Remaining time display: Remaining battery life percent.
Suction atmosphere light: The first gear is blue , the second gear is purple,
and the third gear is red.
J
K
I
A B C D E F G H
