Loading ...
Loading ...
Loading ...
28
Complete Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
33. Power supply cord – Plug into a grounded 3
prong outlet
A
D
B
C
A. Junction box cable
B. Junction box
C. Cable fittings (2)
D. Power cord
Plug into a grounded 3-prong outlet.
34. Reconnect power
Reconnect electrical power at the fuse box or circuit breaker
box.
NOTE: With the access panel off, start the dishwasher and
allow it to complete the shortest wash cycle. After the first
2 minutes, unlatch door, wait 5 seconds, and then open door.
Check that there is water in the bottom of the dishwasher tub.
Check that dishwasher is working properly.
Install Access Panel
35. Install the toe panel
Install the toe panel as shown in the above image.
36. Check toe panel edge
Check that the lower edge of the toe panel touches the floor.
Adjust if necessary.
IMPORTANT: If there is visible gap to the floor after installing
the toe panel, replace it with alternate (tall) toe panel
supplied with dishwasher, shipped at the back of the
dishwasher.
37. Install access panels
Place the access panel against dishwasher legs. Using a
Phillips screwdriver or 1/4" nut driver, reinstall the screws
through the holes in the access panel.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...