Loading ...
Loading ...
Loading ...
27
Option C: Waste disposer – with air gap
A
B
C
D
E
F
G
A. Screw-type clamps
B. Disposer inlet
C. Drain trap
D. Drain hose
E. Rubber hose connector
F. Drain hose clamp (red
color)
G. Air gap
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Connect rubber end (A) of drain hose to air gap and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
4. Attach drain hose to air gap with drain hose clamp (red color)
(provided). Use pliers to squeeze clamp open and move into
position. If the drain hose was cut, use a 1
1
/
2
” to 2" (38 mm to
50 mm)screw-type clamp (not provided).
5. Use a rubber hose (not provided) with screw-type clamps (not
provided) to connect from air gap to disposer inlet.
Option D: No waste disposer – with air gap
B
A
C
D
E
F
G
A. Screw-type clamps
B. Waste tee
C. Drain trap
D. Drain hose
E. Rubber hose connector
F. Drain hose clamp (red
color)
G. Air gap
1. Connect rubber end (A) of drain hose to air gap and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Attach drain hose to air gap with drain hose clamp (red color)
(provided). Use pliers to squeeze clamp open and move into
position. If the drain hose was cut, use a 1
1
/
2
" to 2" (38 mm to
50 mm) screw-type clamp (not provided).
3. Use a rubber hose (not provided) with screw-type clamps (not
provided) to connect from waste tee to air gap.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...