Loading ...
Loading ...
Loading ...
12
Electrical Requirements
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code,
ANSI/NFPA 70 - latest edition, and all local codes and ordinances.
For a fee, a copy of the above code standards can be obtained
from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
You Must Have:
� 120 V, 60 Hz, AC-only, 15 A or 20 A, fused electrical supply.
� Copper wire only.
� A maximum of 2 field wiring supply conductors (12 AWG
largest size) plus 1 grounding conductor are permitted in the
terminal box.
� An included junction box for electrical connection.
We Recommend:
� Install the dishwasher on a circuit with appropriate interrupter
per your local code. The dishwasher is compatible with time
delay fuses, standard circuit breakers, and GFCI and AFCI
circuit breakers.
Circuit Requirement:
� The dishwasher may be installed on the same circuit as a
garbage disposal providing that the branch circuit cannot
exceed rated circuit load and must comply with all governing
codes and regulations such as but not limited to National
Electrical Code, ANSI/NFPA 70 - latest edition.
� No electrical connections other than the dishwasher power
and ground connections can be made inside of the dishwasher
junction box.
If Connecting Dishwasher with a Power Cord:
� Use a UL-listed power cord kit
marked for use with dishwasher. See
the “Tools and Parts” section for part
details.
� Plug into a grounded 3-prong outlet.
Outlet must meet all local codes and
ordinances.
If Connecting Dishwasher with Direct Wiring:
� Use flexible, armored, or nonmetallic
sheathed copper wire with grounding
wire that meets the wiring
requirements for your home and
local codes and ordinances.
� Use only the supplied plastic cable fittings for flexible and
non-metallic sheathed wiring (Romex, etc.). Do not use
metallic strain reliefs for these wire constructions.
� Use a UL-listed/CSA-approved metallic strain relief for
armored cable installations (21 mm diameter).
INSTALLATION INSTRUCTIONS
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
You Need To:
� Slowly open the dishwasher door while someone grasps the
rear of the dishwasher. Remove shipping materials. Place
included parts and literature aside in a safe place for later.
Close dishwasher door until latched.
B
A
C
D
E
A. Cardboard box containing the Accessories
B. Cardboard tube containing the Handle (on some models)
C. 3/8" to 3/4" (9.5 mm to 19 mm) Water Inlet Adapter
D. Assembly accessories
E. Junction box
IMPORTANT: Do not throw away the Cardboard box. It
contains installation materials inside.
NOTE: Each dishwasher is tested at the factory and may
contain some residual water in the tub as a result of the test.
� Observe all governing codes and ordinances.
� Install this dishwasher as specified in these instructions.
� The dishwasher must be installed to meet all electrical and
plumbing national and local codes and ordinances.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...