Loading ...
Loading ...
Loading ...
STEP 8
Adjusting the Air Adjustment Shutter
If Necessary
To determine if the oven burner flames are burning
properly, first remove the oven bottom,
To remove the oven bottom:
1. Remove the knurled
screws holding down
the rear of the oven
bottom.
2. Grasp the oven
bottom at the finger
slots on each side.
3. Lift the rear of the
oven bottom enough
Oven bottom
to clear the tip of the range frame, push it back, and
then pull it up and out.
With the oven bottom
removed, properly c
adjusted flames should
have approximately !
(2.5 cm) blue cones and,
if range is supplied with
natural gas, should burn
with no yellow tipping,.
0Nith most LP gas, small
yellow tips at the end of outer cones are normaL) Flames
should not lift off the burner ports. If lifting is observed,
gradually reduce air shutter opening until flames are
stabilized.
The shutter for the oven burner is near the back wall of
the oven and behind the broiler drawer. To remove the
broiler drawer:
1, Pull the drawer out until it stops, then push it back in
about 1 (2.5 cm)..
2. Grasp the handle, lift and pull the broiler drawer out.
Remove the metal
shield at the rear of
the drawer cavity
The air adjustment
shutter is behind
this shield. To adjust
the flow of air to the
burner, loosen the
Phillips-head screw
and rotate the
shutter to allow
more or less
the burner tube.
Loosen
adjustmentshutter
Metal shield
STEP 9
Leveling the Range
1, Install the oven shelves
in the oven, then position
the range where it will be
installed.
Raise
range
Lower
range
2. Check for levelness by
placing a spirit level or a
partially filled cup of water
on one of the oven shelves.
If using a spirit level, take
two readings--with the level
placed diagonally first in
one direction and then the
other.r (ansomemodels)
3. Remove the storage drawer, broiler drawer, or kick
panel The front leveling legs can be adjusted from
the bottom and the rear legs can be adjusted from
.
5_
the top or the bottom_
Use an open-end or
adjustable wrench to
adjust the leveling legs
until the range is level.
After the range is level,
slide the range away
from the walt so that the
Anti-Tip device can be
installed,
I__' Lower
L,. _ range
(on some models)
38
Loading ...
Loading ...
Loading ...