Loading ...
Loading ...
Loading ...
PREPARATION
• Remove all tape and packaging+ Lift up the cooktop
(on models with standard twin burners) and remove
any packing matedat under ito Make sure the standard
twin burners are properly seated and level.
• Remove plastic film that covers some chrome parts
(around oven door, side trim),
" Take the accessory pack out of the oven..
• Check to be sure that no range parts have come loose
during shipping.
STEP 1
Provide Adequate Gas Supply
Your range is designed to operate at a pressure of
4 (10.2 cm) of water column on natural gas or, if
designed for LP gas (propane or butane), 10 (25A4 cm)
of water column. Make sure you are supplying your range
with the type of gas for which it is designed. This range is
convertible for use on natural or propane gas. If you
decide to use this range on LP gas, conversion must be
made by a qualified LP installer before attempting to
operate the range on that gas+
For proper operation, the pressure of natural gas supplied
to the regulator must be between 4 (10,2 cm) and 13
(33 cm) of water column.. For LP gas, the pressure
supplied must be between 10 (25,4 cm) and 13 (33 cm)
of water column+ When checking for proper operation of
the regulator, the inlet pressure must be at least t
(2.5 cm) greater than the operating (manifold) pressure
as given above The pressure regulator located at the
inlet of the range manifo{d must remain in the supply line
regardless of whether natural or LP gas is being used,,
A flexible metal appliance connecter used to connect the
range to the gas supply line should have an I+D, of i/2
and be 5 feet (t .5 m) in length for ease of installation, In
Canada, flexible connectors must be single wall metal
connectors no longer than 6 feet (1+8m) in length.
STEP 2
Connect the Range to Gas
Shut off the main gas supply vaive before disconnecting
the old range and leave it off unti} new hook-up has been
completed. Don't forget to retight the pilot on other gas
appliances when you turn the gas back on+
Because hard piping restricts movement of the range,
the use of an A_G..A.-certffied flexible metal appliance
connector is recommended unless local codes require a
hard-piped connection+ Never use an otd connector when
installing a new range. If the hard piping method is used,
you must carefully align the pipe; the range cannot be
moved after the connection is made,
To prevent gas leaks, use pipe joint compound
or wrap Teflon* pipe thread tape around all male
(external) pipe threads.
*Teflon: Registered trademark of DuPont
Gas Pipe and Electric Outlet Locations for
Models Equipped with Sealed Burnets
This area attows
for flush range
installation with
through-the-walt
connection of pipe
stub/shut-off
valve and rear
wall 120V outtet+
Shortest
connection from
hard pipestub
4
This area allows for
flush range installation
with through+the"floor
I connection of pipe
_hut-off valve,
32
Loading ...
Loading ...
Loading ...