Loading ...
Loading ...
Loading ...
28
POSSIBLE PROBLEM EASY SOLUTION
Machine will not work when
switched “ON”
The safety locking arm may not be correctly engaged in the vertical operating position with the
locking arm located into the two grooves on either side of the juice cover (see picture on page 10, step 4).
Check the Overload Protection Button on the bottom of the Motor Base to check if the safety device has
not been activated (see Note 3. on page 18 ‘Operating your juicer’).
The Overheating protection device has not been activated automatically, allow more time for the
motor to cool down (see Note 1. on page 18 ‘Operating your juicer’).
Motor appears to stall when
juicing
Wet pulp can build up under the cover if the juicing action is too vigorous. Try slower juicing action by
pushing the food pusher down more slowly. Clean the filter bowl surround, the juice disc and the juicer
cover. Select speed 5 instead of the speed 1 setting.
The Breville Professional 800 Collection Dual Disc Juice Processor will automatically stop operating if the
motor is stalled. This is a electronic safety feature. Either too much food is being processed at one time or
the pieces are not small enough. Try trimming food, cutting food into smaller pieces of even size and/or
processing a smaller amount per batch. If this occurs, the light surrounding the Start/Stop button will flash
red.
To continue juicing, reset the Juicer by pressing the Start/Stop button to ”Off”, then clear the feed chute,
finally turn the appliance back on by pressing the Start/Stop button to “ON”.
Hard fruits and vegetables will put excess strain onto the motor if a low speed is selected. Please refer
to the juicing guide on Page 12, to determine the correct speed for the fruits and vegetables selected on
juicing.
Excess pulp building up the
Stainless Steel Filter Disc
Stop the juicing process. Remove the juicer cover the Stainless Steel scrape off pulp. Re-assemble and
begin juicing again. Try alternating (soft and hard) vegetable and fruit varieties.
Pulp too wet and reduced
extracted juice
Try a slower juicing action. Remove Juice Disc (refer page 9, steps 1 - 8) and thoroughly clean mesh walls
with a fine brush. Rinse Juice Disc under hot water. If the mesh holes are blocked, soak the Juice Disc
in a solution of hot water with 10% lemon juice to unblock the holes or wash in the dishwasher. This will
remove excess fibre build up (from fruit or vegetables) which could be inhibiting the juice flow.
TROUBLE SHOOTING GUIDE
Loading ...
Loading ...
Loading ...