Loading ...
Loading ...
Loading ...
Installing Base with
Vehicle Belt
1
2
3
Place Base in Vehicle Seat
Squeeze the rotation handle and
swivel the seat to face you in
side view.
Squeeze the release handle
located on the front of the car
seat while lifting the car seat off
the base and flipping it over to
the opposite side.
Lay Top Tether Strap Over
the Vehicle Seat
You will be installing the top
tether strap in steps 7 & 8.
Review the vehicle owner’s
manual for the tether anchor
locations.
Open Belt Lock Off
Squeeze the lever to open
the belt lock off & pull it
forward.
4
Weave Vehicle Seat
Belt In and Out of
Belt Path As Shown
Buckle the vehicle belt.
Before installing the car seat in your vehicle, check if the buckle
position needs to be adjusted for your child.
See page 21 for Rear-Facing buckle positions.
See page 28 for Forward-Facing buckle positions.
Review Vehicle Owner’s Manual
Determine what kind of vehicle belts your car has and how to use
them to lock a car seat in place OR where LATCH: lower anchor
seating positions are located in your vehicle.
DO NOT use both the LATCH: lower anchor belt and vehicle belt at the same
time to install the car seat. The car seat is attached to the base via cable wires
and should NOT be removed.
When top tether anchors are available, you MUST ALWAYS attach, adjust, and
secure the tether (top anchorage) strap when installing the car seat in all modes.
DO NOT leave child restraint in Side-Facing mode while vehicle in is motion.
Even when unoccupied, this child restraint
MUST be firmly secured to the
vehicle with the lower anchor belt or with the vehicle seat belt in Rear-Facing or
Forward-Facing mode.
WARNING:
5 6
continued on next page
For LATCH Belt, go to page 9 to bypass the lock off.
For Lap Belt only, skip Step 3 and leave lock off closed.
5
Tighten Belt & Gently
Remove Slack
Place your hand in the base
and firmly push the base
down and back toward the
vehicle seat. Pull the belt
parallel (in line) with the belt
path as shown.
Loading ...
Loading ...
Loading ...