Loading ...
Loading ...
Loading ...
394
• Do not use aerosol products that contain flammable gases inside or around the product. Doing so may
cause fire.
• Do not press too hard on the document table when placing originals.
• Do not open the scanner section while the product is copying, printing, scanning, or performing any
other functions.
• Be careful not to trap your fingers when closing the document cover or scanner.
• Except as specifically explained in your documentation, do not attempt to service or disassemble the
product yourself.
• Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
or the case damaged; if the product does not operate normally or exhibits a distinct change in
performance. Adjust only those controls that are covered by the operating instructions.
• Leave the ink pack installed. Removing the ink pack can dehydrate the print head and may prevent the
product from printing.
• Before transporting the product, make sure that the print head is in the home (far right) position.
• When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down;
otherwise ink may leak.
• Do not attempt to move the product by yourself.
Parent topic: Important Safety Instructions
Ink Pack Safety Instructions
• Keep ink packs and maintenance boxes out of the reach of children and do not drink the ink.
• Be careful when you handle used ink packs; there may be ink remaining around the ink supply port. If
ink gets on your skin, wash it off with soap and water. If it gets in your eyes, flush them immediately
with water. If discomfort or vision problems continue after a thorough flushing, see a doctor
immediately. If ink gets in your mouth, see a doctor right away.
• Do not put your hand inside the product or touch the ink pack during printing.
• Install a new ink pack immediately after removing the expended one. Leaving the ink pack uninstalled
can dry out the print head and may prevent the product from printing.
• Do not remove or tear the label on the ink pack; this can cause leakage.
• Do not remove the transparent seal from the ink supply area. This may cause the ink pack to become
unusable.
• Do not touch the green IC chip on the side of the handle. This may prevent normal operation.
Loading ...
Loading ...
Loading ...