Loading ...
Loading ...
Loading ...
4342
ENEN
Noise could be more marked depending on the
position of the appliance and the surrounding
environment.
Condensation inside and outside of the refrigerator.
If the climate is very humid, the formation of
condensation is normal. Opening the door or draw-
ers for prolonged periods of time can contribute to
the formation of condensation.
In any case, make sure that the doors are always
perfectly closed.
Ice or frost build up inside the refrigerator
or freezer.
Did you leave the doors open for a long period of
time?
Do the doors close perfectly?
If the doors do not close perfectly, contact your
installer.
In case of frost or ice build up in the Fresco com-
partment, due to frequent and prolonged
opening of the doors, deactivate the Crisper-Fresco
function via the button on the control panel. Wait
until the frost or ice melt, then remove the drawer
and dry the sides and bottom of the compartment.
Unpleasant odors inside the refrigerator.
Clean the appliance completely according to the
instructions.
Hermetically cover all the food. Do not conserve
food for prolonged periods of time.
The doors are difficult to open.
The appliance is designed to ensure a fully hermetic
closure. When the door is closed, a vacuum condi-
tion can occur: in this case it is necessary to wait
a few seconds until the pressure balances before
opening the door.
Appliance is cooling but lights and display are not
working.
Check to see if the appliance was accidently placed
into Sabbath Mode
The Ice Maker does not work.
Make sure that the Ice Maker is on (icon ).
The Ice Maker does not produce sufficient amounts
of ice.
On average, the Ice Maker produces approximately
10 cubes of ice every two and half hours.
The ice cubes freeze into one block.
If the ice is not used frequently, it is possible that
blocks of ice may form. It is recommended to re-
move the block of ice cubes and then let the Ice Mak-
er fill the ice tray again. When using ice, be mindful
to bring ice at the back of the bin to the front.
The ice has an unusual flavour or colour.
When the Ice Maker is started for the first time, it
is recommended to empty the first full tray of ice
cubes.
If the refrigerator was switched off for more than
one month or if the cartridge was not changed for
more than six months, it could be necessary to
replace the filter cartridge.
Contact a plumber or a water treatment expert to
make sure that the problem is not due to the water
supply.
If the unit you purchased was used as a show-
room model it may be in a special energy-sav-
ing mode called Demo Mode where the ap-
pliance appears to be operating (lights work
and false temperatures are displayed) but no
cooling actually takes place. If you suspect
your appliance is in Demo Mode please fol-
low the procedure for disabling Demo Mode
described in this manual.
ICE MAKER
> In case of errors, touch the button Alarm and the display will show the error message with its error
number code.
> The message will be shown for 3 seconds, then it will go back to the home screen.
> For longer viewing of the message on the screen, navigate to the INFORMATION menu item ( ). The mes-
sage will be on the screen for 30 seconds, then it will go back to the home screen.
> In the case there is more than one error message, the display will show each message in sequence.
11.2 Malfunction messages appearing on the display
Display message Malfunction description
Power Failure!!
Prolonged interruption of electrical power
the appliance resumes work automatically, the display shows the warmest
temperatures achieved
Door Fridge OPEN
Fridge door open
the message appears after few minutes from the door opening
Fresh Zone OPEN
Freezer door open
the message appears after few minutes from the door opening
Replace filter
Replace filter cartridge
message appears when only 30% of filter capacity is left
Fridge too warm
Fridge too warm
see Troubleshooting Guide
Fridge too cold
Fridge too cold
wait for 12 hours: if malfunction persists call Customer Care for advice
Fresh Zone too warm
Freezer too warm
see Troubleshooting Guide
Fresh Zone too cold
Freezer too cold
wait for 12 hours: if malfunction persists call Customer Care for advice
Error Code...
Functional problems
call Customer Care who may help you to salve the problem or put you in
contact with the nearest Service Agent
Check condenser
Check Condenser
Every 6 months the display shows the message “Check Cond”, clean the
condenser and follow the prompts for resetting or disabling the reminder.
11. TROUBLESHOOTING GUIDE
Loading ...
Loading ...
Loading ...