Loading ...
Loading ...
Loading ...
1
2
ICE MAKER
3332
ENEN
6.1 Internal Layout
(positioning, adjustment, removal)
Crisper Drawer
Fixed to the slide guides with two thumbscrews.
> to remove the drawer, unscrew the thumbscrews,
lift slightly at the front and pull forward. Be sure
to support the rear of the drawer when removing.
Fresh Zone Drawer
The upper Fresh Zone can be removed using the
same method used for the crisper drawer. To
remove the inner Fresh Zone drawer unscrew the
thumbscrews
When replacing the drawers, make certain the
back of the drawers engage under the clips on the
slide guides.
Ice Tray
Located in the upper drawer of the freezer com-
partment on some models. There are feet protru-
ding from the bottom of the ice bin that will situate
it correctly in at the back left of the inner FreshZone
drawer. The notch in the ice collection bin should
be at the back.
> after removal, make sure to reposition it cor-
rectly.
Warning
Do not place hands or fingers near the
Icemaker when in operation.
Shelves
The shelves are positioned on the left and right by
two pins engaged in the shelf supports.
To reposition a shelf it is recommended to removed
contents for safety and ease of movement.
> Lift the shelf slightly and pull towards you to
disengage the pins from the support geometry in
the guides.
> Slide the shelf to the new position and engage
the support pins in the corresponding regions of
the shelf support guides. Prior to loading the shelf
with goods in the new position, test the positioning
for secure support by applying moderate pressure
down on the top surface with a hand while keeping
the other hand in a supporting position in case the
shelf is not properly seated.
Door Bins adjustment
7.1 Use of the Ice Maker
Note
> If the ice is not used frequently is advisable
to empty the ice bin once every 8-10 days.
It is normal that some ice cubes stick to one
another. If the ice is not frequently used, the
older cubes can become opaque, and will
have a strange flavour and become smaller.
> The Icemaker automatically deactivates if
the Vacation
HOLIDAY
function is activated.
When the Icemaker is started for the first
time, it is recommended to dispose of the first
full bin of ice.
> If the equipment has been switched off for
a month or more, it is recommended to per-
form a water
SYS
TEM CLEANING
and filter
WATER FILTER
cleaning cycle.
> The IceMaker only makes ice if the Fresh
Zone compartment is set on Freezer Mode.
Warning
The ice maker will continue to operate
even when the ice bin is not in position
To activate the Ice Maker see section earlier in this
manual.
Please note that 12 to 24 hours are
necessary before ice production may begin.
The production is of 10 cubes per cycle in
approximately 10 cycles in 24 hours.
The yield depends on the temperature set in the
freezer, the room temperature and the frequency of
drawer / door opening.
If the appliance is operating without being connected
to the water system, make sure that the Icemaker
is deactivated. The Ice Maker produces ice until the
ice tray is full and will automatically stop once the
maximum level is reached.
With the Fast Ice
FAST ICE
function, it is possible to
increase the quantity of ice produced in 24 hours,
while the Set Cube Size
SET CUBE
SIZE
function permits
selection of the size of the produced ice cubes.
Do the ice cubes have an unusual odor?
Ice is a porous material which can absorb odors
from the environment. Ice cubes which have been
in the ice cube container for a long time may absorb
odors, stick together and slowly become smaller.
We recommend that old ice cubes not be used.
Other means of preventing odors:
> The ice cube container should be cleaned
occasionally with warm water. Make sure that
you switch off the ice maker before clearing the
container. Rinse out and wipe dry.
> Check the contents of the freezer for spoiled
or out-of-date food. All odorous foods should be
wrapped thoroughly or stored in airtight containers
to prevent the build-up of odors.
> The water filter may have to be replaced in some
models.
> In some cases the quality of the water connection
in the house should be checked.
Operating noises
Quite normal noises
> Grumbling: refrigerating unit is running. Fan in the
recirculating air system is running.
> Bubbling, humming or gurgling noises: refrigerant
is flowing through the tubes.
> Clicking: motor is switching on or off. Solenoid
valve on the water connection is opening/closing.
> Rumbling: ice cubes are falling into the ice cube
container.
The appliance is powered by two independent
compressors. It is therefore normal to always
have one of two compressors in operation.
Warning
Do not place any bottles or food for rapid
cooling in the ice cube container. The
ice maker may become blocked and be
damaged.
6. INTERNAL LAYOUT 7. USE OF THE ICE MAKER
Loading ...
Loading ...
Loading ...