TRG3601 Use and Care Manual

Loading ...

CONNECT RANGE TO GAS SUPPLY

Most localities will require that the stove shutoff valve and gas connections be installed by a certiﬁed

technician or plumber. These instructions are for a professional. Gas installation speciﬁcations and reg-

ulations may vary so please consult your local codes before proceeding.

a. Install a manual gas line shut-off valve in the gas line as follows:

· in an easily accessed location outside the range.

· in the gas piping external to the appliance.

b. Install male 1/2” ﬂare union adapter to 1/2” NPT internal thread elbow at inlet of

regulator.

On models equipped with standard twin burners, install the male pipe thread end of the 1/2” ﬂare

union adapter to the 1/2” NPT internal thread at inlet of pressure regulator.

Use a wrench on the regulator ﬁtting to avoid damage.

c. Install male 1/2” or 3/4” (3/4” refers to 48-inch gas range) ﬂare union adapter to the

NPT internal thread of the manual shut-off valve, taking care to secure the shut-off

valve to keep it from turning.

d. The gas supply pressure for checking the regulator setting is 6 in.w.c. (Nature Gas)

and 11 inch.w.c. (LP gas) connect ﬂexible gas line connector to the regulator on the

range. Position range to permit connection at the shut-off valve.

e. When all connections have been made, make sure all range controls are in the

position and turn on main gas supply valve.

f. Leak testing of the appliance shall be conducted according to the manufacturer’s

instructions. Use some soap water (50% water and 50% soap) or a leak detector at

all joints and connections to check for leaks in the system. Do not use a ﬂame to

check for gas leaks.

g. The appliance must be isolated from the building’s gas supply piping system by

closing its individual manual shut-off valve during any pressure testing of the gas

supply piping system at test pressure equal to or less than 1/2 psig(3.5kPa).

CONNECT RANGE TO GAS SUPPLY

After installation

a. Check ignition of cooktop burners.

b. Check ignition of oven burner.

c. Visually check tubular burner (oven burner) re-ignition to be sure both rows of burner

ports are relighting each time.

d. Check for gas leaks at all gas connections (using a gas detector, never a ﬂame).

e. Check oven bake and convection bake function.

Loading ...

Thor Kitchen TRG3601 36 Inch Freestanding Professional Gas Range with 6 Sealed Burners, 6 cu. ft. Oven Capacity