Husqvarna K 970 SMARTGUARD K 970 SmartGuard Power Cutter

Operator's Manual - Page 33

For K 970 SMARTGUARD.

PDF File Manual, 152 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Problem Cause Possible solutions
The vibration levels are too
high.
The cutting blade is installed incor-
rectly.
Make sure that the cutting blade is correctly
installed and that it is not damaged. Refer to
To install the cutting blade on page 15
.
The cutting blade is defective.
Replace the cutting blade and make sure
that it is not damaged.
A vibration damping unit is defective. Speak to your service agent.
The temperature of the prod-
uct is too high.
The air intake or the cylinder flanges
are blocked.
Clean the air intake and the cylinder flanges.
The drive belt tension is not suffi-
cient.
Examine the belt. Adjust the tension.
The clutch is defective.
Always cut at full throttle.
Examine the clutch. Speak to your service
agent.
The engine decreases in
power or in speed.
The air filter is clogged. Examine the air filter. Refer to
To examine
the air filter on page 31
.
There is much dust during
operation. You can see dust
in the air.
The water supply or water pressure
is not sufficient.
Do a check of the water supply to the prod-
uct.
Refer to
To do a check of the water supply
system on page 32
.
The SmartGuard does not
move freely.
The SmartGuard does not re-
tract when the product is re-
moved away from the work
piece.
The moving parts of the SmartGuard
are clogged.
Clean the moving parts.
The springs of the SmartGuard does
not operate correctly.
Do a check of the springs. Clean the springs.
Transportation, storage and disposal
Transportation and storage
Safely attach the product during transportation to
prevent damage and accidents.
Remove the cutting blade before transportation or
storage of the product.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Keep the cutting blades in dry, frost free conditions.
Examine all new and used blades for transport and
storage damage before assembly.
Clean and maintain the product before storage.
Refer to
Maintenance schedule on page 26
.
Remove the fuel from the fuel tank before long-term
storage.
Disposal
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
When the product is no longer in use, send it to a
HUSQVARNA dealer or discard it at a recycling
location.
1429 - 002 - 04.05.2021 33
Loading ...
Loading ...
Loading ...