Husqvarna K 970 SMARTGUARD K 970 SmartGuard Power Cutter

Operator's Manual - Page 19

For K 970 SMARTGUARD.

PDF File Manual, 152 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Divide the pipe into 5 sections. Do a mark of those
sections and of a cutting line. Cut a shallow guide
groove around the pipe.
4
1
2
3
5
Cut those sections in 5 steps with the cutting
directions shown by the arrows in each step.
1
2
3
4
Make the final separating cut from the top of the pipe
pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
5
WARNING: If the pipe is properly
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched in
the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
To prevent a kickback
WARNING:
Avoid situations where
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING: Be careful when you put
the blade in an existing cut.
WARNING: Make sure that the work
piece cannot move during a cutting
operation.
WARNING: Only you and proper
working technique can eliminate kickback
and its dangers.
1429 - 002 - 04.05.2021 19
Loading ...
Loading ...
Loading ...