Husqvarna K 970 SMARTGUARD K 970 SmartGuard Power Cutter

Operator's Manual - Page 32

For K 970 SMARTGUARD.

PDF File Manual, 152 pages, Download pdf file

Loading ...
Loading ...
Loading ...
a) Loosen the screw (A) and remove the air filter
(B).
A
B
b) Install the air filter.
5. Attach the air filter cover and tighten the 4 screws.
To do a check of the water supply
system
1. Examine the nozzles on the blade guard and make
sure that they are not clogged.
2. Clean as necessary.
3. Examine the filter on the water connector. Make sure
that it is not clogged.
4. Clean as necessary.
5. Examine the hoses and make sure that they are not
damaged.
Troubleshooting
Problem Cause Possible solutions
The product does not start.
The start procedure is done incor-
rectly.
Refer to
To start the product with a cold en-
gine on page 23
and
To start the product
with a warm engine on page 24
.
The stop switch in the right (STOP)
position.
Make sure that the stop switch (STOP) is in
the left position.
There is no fuel in the fuel tank. Fill with fuel.
The spark plug is defective. Replace the spark plug.
The clutch is defective. Speak to your service agent.
The cutting blade rotates at
idle speed.
The idle speed is too high. Adjust the idle speed.
The clutch is defective. Speak to your service agent.
The cutting blade does not
rotate when the operator
throttles up.
The belt is too loose or defective.
Tighten the belt or replace the belt with a
new one.
The clutch is defective. Speak to your service agent.
The cutting blade is installed incor-
rectly.
Make sure that the cutting blade is correctly
installed.
The product has no power
when the operator tries to
throttle up.
The air filter is clogged.
Examine the air filter. If it is necessary, re-
place it.
The fuel filter is clogged. Replace the fuel filter.
The fuel tank flow is blocked. Speak to your service agent.
32 1429 - 002 - 04.05.2021
Loading ...
Loading ...
Loading ...