Husqvarna K 970 SMARTGUARD K 970 SmartGuard Power Cutter

Operator's Manual - Page 27

For K 970 SMARTGUARD.

PDF File Manual, 152 pages, Download pdf file

Loading ...
Loading ...
Loading ...
1. Loosen the 4 screws and remove the air filter cover.
2. Make sure that the spark plug cap and ignition cable
are not damaged.
WARNING: A damaged spark plug
cap and ignition cable can cause
electrical shock.
3. Clean the spark plug if it is dirty.
4. Make sure that the electrode gap is 0.5 mm.
5. If it is necessary, replace the spark plug.
To do a general inspection
Make sure that all nuts and screws on the product
are tightened correctly.
To replace the drive belt
WARNING: Do not start the product
without all guards and covers installed.
1. Loosen the screw (A).
A
B
C
Note: This step only applies to K 970 III 400mm/
16in..
2. Loosen the 3 nuts on the cutting head (B) and turn
the belt tensioner (C) to the position "0".
3. Remove the front belt guard.
4. Remove the 2 screws on the rear belt guard.
Remove the rear belt guard.
1429 - 002 - 04.05.2021
27
Loading ...
Loading ...
Loading ...