PetSafe PCF-1000-20 Operating Guide

Loading ...

10 www.petsafe.net

The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains

in the Static Correction Zone, if the collar is set at level 2 or above.

The฀Receiver฀Indicator฀Light฀acts฀as฀a฀low฀battery฀indicator,฀ashing฀every฀60฀seconds฀when฀battery฀replacement฀is฀required.

Over Correction Protection

In฀the฀unlikely฀event฀that฀your฀cat฀“freezes”฀in฀the฀Static฀Correction฀Zone,฀this฀feature฀limits฀the฀static฀correction฀duration฀

to 30 seconds. The system locks out further static correction until the pet leaves the Static Correction Zone.

Function and Response Table

Note: Begin training with Correction Level 2 and only increase if your cat does not respond to the Static Correction.

Indicator Light

Response

Static Correction

Level

Receiver Collar Function Temperament of cat

1 Flash 1 No Static Correction, Beep Only

2 Flashes 2 Low Static Correction Timid

3 Flashes 3 Medium Static Correction Timid or Average

4 Flashes 4 Medium-High Static Correction Average฀or฀High฀Energy

5 Flashes 5 High Static Correction High฀Energy

Flashes once every

4 to 5 seconds

Low Battery

____________________________________________________________________________________________________

Set the Boundary Width and Test the Receiver Collar

The Boundary Control Switch on the side of the

Fence฀Transmitter฀has฀three฀settings฀(6A).฀Setting฀B

is used for most properties. The following table will

indicate the setting you should use.

Amount of Wire Setting

Up฀to฀400฀m฀(1300฀ft)

400-730฀m฀(1300-2400฀ft)

Greater฀than฀730฀m฀(2400฀ft)

Use the Boundary Width Control knob to set the

width of the Warning Zone and Static Correction

Zone฀(6B).฀Set฀the฀Boundary฀Width฀as฀wide฀as฀

possible to give your cat the widest Warning and

Static Correction Zones without reducing the

6B6A

Pet Area too much. We recommend a 3.7-6 m

(12-20฀ft)฀Boundary฀Width.฀

Note: The Boundary Width Control knob does not change the Static Correction Level.

To identify the Warning and Static Correction Zones, make sure the Receiver Collar

battery is properly installed, the Static Correction Level is set at 2 or above, and the

Test฀Light฀contacts฀are฀held฀to฀the฀Contact฀Points฀(6C).฀For฀best฀results,฀select฀a฀

section฀of฀straight฀Boundary฀Wire฀that฀is฀at฀least฀15฀m฀(50฀ft)฀long.฀Hold฀the฀Test฀

Light฀tool฀contacts฀to฀the฀Contact฀Points฀(6C).฀Walk฀toward฀the฀Boundary฀Wire฀with฀

Contact Points pointing up and holding the Receiver Collar at your pet’s neck level

(6D)฀until฀the฀Receiver฀Collar฀beeps฀(6E)฀and฀the฀Test฀Light฀Tool฀ashes.

Note: The Receiver Collar is waterproof, which can make the beep hard to hear.

If the Receiver Collar does not beep at the desired range, adjust the Boundary

Width Control knob to the desired setting. Turning the Boundary

Step

Loading ...

PetSafe PCF-1000-20 In-Ground Cat Fence - Waterproof - Tone and Static Correction - Stretch-Section

Operating Guide - Page 10