Loading ...
Loading ...
Loading ...
The problem Try this!
The message "Connecting
to Anynet+ device..." or
"Disconnecting from Anynet+
device" appears on the screen.
You cannot use the remote control when the Projector is conî©£guring Anynet+ or
switching to the Projector viewing screen.
Use the remote control after the Projector has completed the Anynet+ conî©£guration
or has switched to the Projector viewing screen.
The Anynet+ device won't play. You cannot use the play function when Reset is in progress.
The connected device is not
displayed.
Check whether the device supports Anynet+.
Anynet+ devices must be connected to the Projector using an HDMI cable. Make sure
the device is connected to your Projector with an HDMI cable. Some HDMI cables may
not support Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC) and see if Anynet+ (HDMI-CEC) has been set to On.
• Settings General External Device Manager Anynet+ (HDMI-CEC)
Scan for Anynet+ devices again.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
Remote Control Issues
When the remote control isn't working, these steps may help resolve the problem.
The problem Try this!
The remote control does
not work.
The connection between the Samsung Smart Remote and the Projector may be lost.
Point the Samsung Smart Remote at the front of the Projector, and then press and hold the
and buttons simultaneously for 3 seconds or more.
Also, if the remote control is not working or slow, the batteries might be low or dead. If this
is the case, replace the batteries. Alkaline batteries are recommended for longer battery
life.
External devices cannot be
operated with the Projector
remote control.
Check the cable connection between the Projector and external devices.
When the symptom persists, set it manually in Source Universal Remote Setup.
- 134 -
Loading ...
Loading ...
Loading ...