Loading ...
Loading ...
Loading ...
30
FAULT
POSSIBLE CAUSE
TROUBLESHOOTING
Stains
remain on
dishes.
Not
enough detergent was used.
Use the correct amount of detergent, as
instructed in the program table.
Rinse
aid dosage and/or water
softener setting set too low.
Increase rinse aid and/or water softener
level.
High water hardness level.
Increase the water softener level and add
salt.
The
salt compartment cap is not
closed properly.
Check that the salt compartment cap is
closed properly.
Dishes
do not dry.
The drying option was not
selected.
Select a program with a drying option.
Rinse aid dosage set too low.
Increase rinse aid dosage setting.
Rust
stains forming
on
dishes.
The
stainless-steel quality of the
dishes is insufficient.
Only use dishwasher-safe sets.
High
level of salt in the water.
Adjust the water hardness level using a
water hardness table.
The
salt compartment cap is not
closed properly.
Check that the salt compartment cap is
closed properly.
Too much salt was spilled in the
Dishwasher while filling it with salt.
Use a funnel while pouring salt into the
compartment to avoid spillage.
Poor electrical grounding system.
Consult a qualified electrician
immediately.
Detergent
remains in
the
detergent
compartment.
Detergent was added when the
detergent
compartment was wet.
Make sure the detergent compartment is
dry before use.
If your appliance shows other symptoms than those described above, or if you have checked all
items listed as the cause and the problem still exists, then call Summit Appliance Customer Service
at
1-800-932-4267 or visit www.summitappliance.com/support.
Loading ...
Loading ...
Loading ...