Loading ...
Loading ...
Loading ...
_I, CAUTION: Do not operate this lawn
mower without the discharge guard or an
entire approved grass catcher in place.
These guards are for your protection and
are required by the American National
Standards Institute and Consumer Prod-
ucts Safety Commission.
,Ii_CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug,
HOW TO SET UP YOUR MOWER
UNFOLD HANDLE
IMPORTANT: Unfold handle carefully so
as not to pinch or damage control cables.
2 POSITION / "ADJUSTABLE" HANDLES
• Raise handles until lower handle section
locks into place in operating position.
"QUICK RELEASE" HANDLES
• Move height adjustment lever forward to
raise mower to highest position.
• Tighten handle bolts (on both sides).
Operator MOWING
presence
LIFT
UP
Upper
handle
Handle
lever
handle
Handle
bolt
Height
adjuster
lever
LEVER
FORWARD
TO RAISE
MOWER
3 POSITION "EZ" HANDLES
• Raise lower handle section to operating
position and align hole in handle with
one of three height positioning holes.
• Insert handle bolt through handle and
bracket and secure with knob.
° Repeat for opposite side of handle.
Handle
bracket
Knob
Belt
3 POSITION "QUICK" HANDLES
• Raise lower handle section to operating
position and squeeze the bottom ends
of lower handle towards each other
until the pin in handle can be inserted
into one of the three height adjustment
holes,
Handle pin
SQUEEZE
J
Handle
adj
bracket
ALL HANDLES
° Raise upper handle section into place on
lower handle, remove protective padding
and tighten both handle knobs.
° Remove handle padding holding opera-
tor presence control bar to upper handle.
° Your lawn mower handle can be ad-
justed for your mowing comforL Refer to
"ADJUST HANDLE" in the Service and
Adjustments section of this manual.
NOTE: For shipping purposes, the rear
wheels on your tawn mower may not be
adjusted to the same position as the front
wheels. Before operating mower adjust all
5 wheels to the same cutting height.
Loading ...
Loading ...
Loading ...