Loading ...
Loading ...
Loading ...
"THREE POINT" ADJUSTMENT
(18" (45cm) Ht-VAC MODELS ONLY)
Both rear wheels are adjusted by a single
lever on the left rear wheel.
• Pull adjuster lever toward wheel. To
raise mower, move lever forward to
desired position. TO lower mower, move
the ]ever toward the rear.
NOTE: There are seven (7) height adjust-
ment positions for the rear wheels.
Both front wheels are adjusted as follows:
t. Remove wheel, bolt, and hardware and
reassemble in desired adjustment hole.
2. Reinstall wheel components in the
same order as they were before re-
moval. Tighten securely.
NOTE: There are seven (7) height adjust-
ment holes for the front wheels. Be sure
both front wheels are in the same hole.
IMPORTANT: Be sure to adjust both front
and rear wheels to the same height.
LEVER BACKWARD
TO LOWER REAR
OF MOWER
usterlever
LEVER FORWARD
TO RAISE REAR
OF MOWER
Bolt
Lockbar
position)
Wing
Washel
Lockbar
("freewheel"
position)
CASTER WHEEL OPERATION '
('q'HREE POINT" ADJUSTMENT ONLY)
The front wheels can be "locked" into
position or set to "freewheel" for better
maneuverability. Placing the lockbars in
the outer holes of the adjustment brackets
"locks" the front wheels. Likewise, placing
the tockbars in the inner holes of the ad-
justment brackets allows the front wheels
to spin freely ('_freewheel").
- Lift tockbar until the frontmost end clears
the adjustment bracket, then pivot lock-
bar to desired position.
IMPORTANT: Front wheels must be
"looked" into position when operating on
a slope. Mow across the face of slopes:
never up and down.
TO CONVERT MOWER:
Most mowers are shipped ready to be
used as a mutcher,
"REAR DISCHARGE ONLY" MOWERS
Some models have a seperate mulcher
plug, other models have the muicher plug
built into the rear door. To convert to bag-
ging or discharging, the plate or plug (if
so equipped) must be removed from the
discharge opening of the lawn mower,
• Open rear door and remove muicher
plate or plug (if so equipped). Store
mutcher plate or plug in a safe place.
• You can now install grass catcher or
optional clipping deflector accessory.
• To return to mulching operation, install
mutcher plate or plug into discharge
opening of mower.
• I,CAUTION: Do not run your fawn mower
without mulcher plate/plug in place or ap-
proved clipping deflector or grass catcher
in place. Never attempt to operate the
lawn mower with the rear door removed or
propped open.
MULCHER
"PLATE"
Mulcher
plate tabs
MULCHER
"PLUG"
Mufcher
plug
MULCHER PLUG BUILT INTO REAR DOOR
11
Loading ...
Loading ...
Loading ...