Loading ...
Loading ...
Loading ...
6. Equipment service
(1) screw cleaning and lubrication
When the machine is in use, it is a good habit. It is necessary to do a cleaning
work for about one month. The screw, optical axis and bearing cleaning must
work. You can use a clean rag to manually wipe the optical axis of the screw.
The part of the bearing that is not cleaned can be cleaned with a small brush.
After cleaning, the oil can be sprayed with oil to the screw, the optical axis and
the bearing, and then the machine can be moved back and forth for a few times,
such as above the screw. There is also dirt, re-clean with a rag, repeat the
lubrication and clean the action until the screw is shiny and oily.
(2) spindle cleaning and maintenance
During the machining process, the spindle chuck, nut and screw parts are easy to
enter dust and rust. At this time, it is necessary to apply anti-rust oil to the spindle
clamping part to clean the rust of the screw; the chuck and nut are severely rusted.
Replace the collet and nut to ensure that the machine is concentric.
(3) electric control box cleaning
When the controller is used with the machine, sometimes it will enter a lot of dust.
When processing metal materials, it is necessary to clean the dust inside the control
box to prevent conduction and burn out the circuit. We can open the cover of the
controller, use a hair dryer, open the cold air stall, turn the control box upside down,
clean the dust on the circuit board, and clean it, clean it with a small brush.
(4) common consumables replacement
Shaft nuts, chucks, knives, stepper motor couplings, lubricants,
etc., please contact
Supplies Name
Consumables Picture
Supplies Features
Spindle nut
On the clamping spindle, use
the locking tool with the tool
chuck
Tool chuck
On the clamping spindle, use
the locking tool with the tool
nut
Tool
Engraving tools such as
engraving knives, milling
cutters, drill bits, etc.