Loading ...
Loading ...
Loading ...
W415-1101 / B / 07.29.13
10
EN
4.0 FINISHING
A. Either sand for natural gas models (GL22N, GL28N, GL32N) or glass for propane models (GL22P,
GL28P, GL32P), must be spread evenly over the burner pan with a gradual downward slope toward
the front of the burner pan.
B. Tear the ember material into small thin pieces and spread evenly on top of the media. Ember material
will only glow when exposed to direct fl ame.
NOTE: DO NOT OVERFILL. DO NOT COVER THE PILOT WITH MEDIA OR EMBERS.
A. Sprinkle the charcoal embers around the front and sides of the burner pan, as indicated on the
diagram below.
B. Place the charcoal lumps on top of the charcoal embers at the front of the media.
NOTE: Do not block air shutter opening with charcoal embers or lumps.
BURNER PAN
GRATE
GL22 FRONT VIEW
HEAT SHIELD
BURNER PAN
AIR SHUTTER
(PROPANE
MODELS ONLY)
GRATE
GL 28 / GL32 TOP VIEW
CHARCOAL
EMBERS
CHARCOAL
LUMPS
GLOWING
EMBERS
4.1 GRATE INSTALLATION
4.2 SAND OR GLASS MEDIA PLACEMENT
4.3 CHARCOAL LUMPS/EMBERS
A. For the best fl ame performance and least carbon, position the grate as far back as possible.
B. Secure the heat shield to the back of the burner pan with the 2 supplied screws (for GL22 model only),
see Figure 1.
C. Secure the grate to the burner pan using one supplied screw, attached to the burner pan (for GL28/
GL32 models only), see Figure 2.
FIG. 1
FIG. 2
Loading ...
Loading ...
Loading ...